Page 1 of 1

How: Insert Tailwheel spring into Pivot fitting?

PostPosted: Sat Mar 17, 2018 6:22 pm
by dhogue
Hello Sonex/Onex builders,

I am writing to ask how did you install SNX-LO3-03 Tail Wheel Spring into the ONX-LO3-04 Tailwheel Pivot fitting?
The plans page is ONX-LO3

The spring will not slide into the pivot fitting. I tried to tap it in with a hard rubber mallot but it does not go in at all.

Thanks,
Don

Re: How: Insert Tailwheel spring into Pivot fitting?

PostPosted: Sat Mar 17, 2018 6:25 pm
by Direct C51
Don, that sounds like the better problem to have than it fitting quite loosely like mine did. I would just use some sand paper or a scotch brite pad on a stick chucked in a drill motor to remove some of the powder coating in the pivot assembly. Remove just enough to get it in. The tighter the better.

Re: How: Insert Tailwheel spring into Pivot fitting?

PostPosted: Mon Mar 19, 2018 3:33 pm
by dhogue
Thank you Sir!
That worked.
Don