SNX-F08 seat pan stick holes in right spot?

Discussion for Sonex builders on specific plans page experience. These posts are limited to technical suggestions such as assembly order, challenges, or techniques related to specific plans pages.

Re: SNX-F08 seat pan stick holes in right spot?

Postby Bryan Cotton » Wed Feb 22, 2017 7:59 am

If you want a sanity check, look at your mixer mount. The stops are built in and the lever arm from the pivot to the stop can be measured. Then you can ratio the motion by the idler and lever arm on the stick assembly. The hole clear the front of the stick where the bottom of the pivot is. On the backside my aileron stop hit the skin. This would be a good engineers week project to model up.
Bryan Cotton
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
User avatar
Bryan Cotton
 
Posts: 4957
Joined: Mon Jul 01, 2013 9:54 pm
Location: C77

Previous

Return to Sonex Plans

Who is online

Users browsing this forum: No registered users and 2 guests