Re: Cotton Waiex 191 - N191YX
Posted: Wed Dec 20, 2017 11:40 pm
First hole drilled in the plexiglass:
To transfer holes from the hinge to the canopy, we made this tool. It is a hunk of scrap with a #30 hole in it.
A #30 bit aligns the tool with the hole. The bit is removed and the tool held steady. The other builder uses it to align the bit.
Here is the right side clecoed.
For the left side, we freehanded 4 holes by looking through the plexiglass and lining up the bit with the frame. Then we clecoed on the trim piece and used the tool for the rest of the holes.
To transfer holes from the hinge to the canopy, we made this tool. It is a hunk of scrap with a #30 hole in it.
A #30 bit aligns the tool with the hole. The bit is removed and the tool held steady. The other builder uses it to align the bit.
Here is the right side clecoed.
For the left side, we freehanded 4 holes by looking through the plexiglass and lining up the bit with the frame. Then we clecoed on the trim piece and used the tool for the rest of the holes.