by Bryan Cotton » Wed Dec 23, 2015 12:50 pm
On the trailing edge of the wingtip I could not transfer most of the holes from the angle to the tip. So I made my own hole duplicator out of a piece of mild steel.
I had bent it around a scrap piece of fiberglass and aluminum to get the spacing right, then used those same scraps to drill holes in the press. Here it is in action. Worked great.
Bryan Cotton
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23