Page 1 of 3
555 Waiex build update
Posted:
Sat Dec 19, 2015 11:13 amby Fritz
The fuselage is coming together. The aft fuselage is just about done and we've got a good start on the forward fuselage. The wings were part of EAA's "Give Flight" program, they were built at Oshkosh and given to our chapter. We just have to buy the rest of the kit, build it and fly it to Oshkosh 2017.
The kits going together pretty fast so, if we don't run into too many snags, we should have it done in time.
Re: 555 Waiex build update
Posted:
Sat Dec 19, 2015 1:33 pmby Bryan Cotton
Looks great Fritz! Heck maybe you can make Oshkosh 2016!
Re: 555 Waiex build update
Posted:
Sat Dec 19, 2015 8:22 pmby Fritz
Thanks, So far it's going pretty good.
If we had the engine lined up we could almost make Oshkosh 2016 ;)
555 Waiex build update
Posted:
Sat Dec 19, 2015 9:47 pmby Sonex1517
So cool to watch the progress on this project!
Robbie Culver
Sonex 1517
Chicagoland
First flight 10/10/15
10 hours in phase one
N1517S
Re: 555 Waiex build update
Posted:
Sat Jan 02, 2016 3:08 amby Fritz
Quick update:
I made the canopy latch plates on a CNC machine today. This was my first attempt at cutting phenolic on the machine, it seemed to work great. I feel better about cutting the heavier phenolic parts now.
Fritz
Re: 555 Waiex build update
Posted:
Sat Jan 02, 2016 8:33 amby Bryan Cotton
I KNEW there was a tool I was lacking. Darn! Very nice!
Re: 555 Waiex build update
Posted:
Sat Jan 02, 2016 1:37 pmby LarryEWaiex121
Fritz,
Mine are essentially, "worn out" as I get my plane ready for the 2016 flying season. Would you be interested in whipping out another set for a reasonable fee?
When I pull my headsets off while idling I can hear a chatter that's coming from the canopy and realized about my last flight out its the phenolic wearing out from sliding the canopy latch forward and back. Plus the stresses it goes through in normal flight.
Like any plane some things begin to show wear. At 458 hrs I don't think two phenolic blocks will break me.
You might have a small cottage industry if you sort out that CNC machine!
Larry
Waiex121YX, Camit 3300 going in soon. 458hrs Airframe
Re: 555 Waiex build update
Posted:
Sat Jan 02, 2016 8:26 pmby Fritz
Hi Larry,
I can cut another set. You probably want them without mounting holes so you can match them to your longerons?
How about $5 a set plus shipping?
Fritz
Re: 555 Waiex build update
Posted:
Sat Jan 02, 2016 10:38 pmby chris
I'm getting ready to make those.
I'd love to get in on that if you were willing to make another.
Re: 555 Waiex build update
Posted:
Sat Jan 02, 2016 11:16 pmby Fritz
Sure, I'll make a few extra sets just in case.
I'll start a new thread to see if anyone else wants a set, that way I can do it all in one setup.